流动注射分光光度法测定水中六价铬的研究

研究建立了测定水中六价铬的流动注射光度分析方法,探讨了利用抗坏血酸的还原性扣除水样中轻度色度或浊度干扰的可行性.本方法线性关系好,检出限低,精密度和准确度高,对地表水、地下水、生活污水、工业废水等实样的测定获得了令人满意的结果.与传统的二苯基碳酰二肼分光光度法相比,具有方法简单、灵敏度高、分析速度快等优点,适用于环境监测的分析工作.     

基于石墨烯构建的电化学传感器在环境监测中的应用

综述了基于石墨烯构建的电化学传感器在重金属、有毒气体、农药残留、酚类有机污染物等对环境造成一定危害的物质检测中的应用,并展望了石墨烯电化学传感器在环境监测领域中的发展。     

污水污泥裂解及其性能的研究

以碘吸附值为裂解残渣吸附性能的指标，通过单因素实验和正交实验，确定了制备裂解残渣的最佳工艺条件，并对残渣的表面元素组成、孔结构组成、晶相组成和吸附性能等性质进行了表征。结果显示：以浓度均为5 mol/L的ZnCl₂和H₂SO₄作活化剂、复配比2∶1、活化温度600℃、活化时间1 h、固液比1∶2.5，制得的裂解残渣酸洗后碘值平均值可达892.8 mg/g；用制备的裂解残渣对苯酚废水进行处理，室温下振荡5 min，苯酚去除率即可达到87.9%，且符合Langmuir吸附等温线方程和Freundlich吸附等温线方程。     

板栗壳对重金属Cr（Ⅵ）吸附性能的研究

从废弃的植物材料中筛选出一种Cr(Ⅵ)高效吸附剂——板栗壳。研究了pH、接触时间、板栗壳用量、温度和Cr (Ⅵ)初始浓度对Cr(Ⅵ)吸附活性的影响。结果表明, 板栗壳的最佳pH为2～3。在pH 2时,Cr(Ⅵ)的去除率达99.7%。在15～35℃的温度范围内,板栗壳对Cr(Ⅵ)的去除率随温度的升高而增加。30℃时,Cr(Ⅵ)的去除率可达99%。板栗壳用量对Cr(Ⅵ)的去除有明显影响。由0.2 g增加到0.4 g时, Cr(Ⅵ)的去除率从90.6%提高到99%。在较宽的铬初始浓度范围内,板栗壳对Cr (Ⅵ)有明显的去除作用。     

添加天然沸石和石灰对土壤镉形态转化的影响

采用土壤培养实验,研究镉污染土壤中添加沸石、石灰及两者配施对土壤pH值和土壤镉形态变化的影响。结果表明,土壤pH值随沸石用量的增加而增加,随培养时间呈现先增加后下降并逐渐趋于稳定的趋势,但均高于对照。高剂量石灰的处理对土壤pH的影响最大,与对照相比土壤pH提高了3.33个单位。在土壤5~50 d培养过程中,石灰处理的土壤交换态镉含量呈现先逐渐降低而后略有升高的趋势,其余处理均呈下降趋势。培养50 d后,高剂量的沸石、石灰及高剂量沸石与石灰配施处理的土壤交换态镉含量从5 d时的67.54、61.95和55.56 mg/kg降低至54.65、49.93和45.96mg/kg。相关分析表明,不同培养时期交换态镉含量与土壤pH值呈负相关关系。在10个处理中,L2Z3(石灰2 g/kg土和沸石60 g/kg土)组合处理效果最好,使土壤交换态镉含量下降了34.68%,碳酸盐结合态镉含量上升了4.30%,铁锰氧化结合态镉含量上升了16.97%,有机结合态镉含量上升了1.31%,残渣态镉含量上升了12.11%。     

铬渣秸秆共热解产物铬稳定性研究

生物质铬渣共热解工艺是新型的铬渣处理工艺,该工艺能有效地将铬渣中的Cr(Ⅵ)还原为Cr(Ⅲ).而由于共热解产物总铬含量较高,因此考察了铬渣与秸秆共热解过程中铬稳定性.通过考察共热解产物成分及形态分析、pH影响实验、淋洗实验及长期稳定性实验,对共热解铬渣的铬环境安全性进行评估.结果表明:(1)共热解温度对铬渣形态有较大影响,可交换态及碳酸盐结合态铬含量随共热解温度升高而逐渐降低,800℃时候可交换态铬降至＜0.1％(质量分数,下同),碳酸盐结合态铬为1.2％;共热解后最稳定的残渣态铬含量随共热解温度升高而逐渐升高.(2)当pH＞7时,两种共热解产物总铬溶出量极低,基本都小于6mg/kg;当pH≤7时,总铬的溶出量显著增加,最高超过500 mg/kg.但由于解毒铬渣的酸中和能力极强,因此铬释放风险较低.(3)共热解产物的总铬累积溶出量极低,根据拟合结果计算出其100年填埋时间的总铬溶出量不超过1.3 mg/kg.长期稳定性实验表明,自然堆置过程中共热解产物的Cr(Ⅵ)含量逐渐降低.     

Removal of Cr(VI) from simulative contaminated groundwater by iron metal

The Cr(VI) removal from simulative contaminated groundwater using zero-valent iron (Fe⁰) filings, Fe⁰ powder and nanoscale Fe⁰ in batch experimental mode was studied. Cr(VI) is a primary pollutant of some soils and groundwater. Zero-valent iron, an important natural reductant, could transform Cr(VI) to Cr(III) which is much less toxic and immobile. The Cr(VI) removal percentage was 87% at a metal to solution ratio of 6 g l⁻¹ for commercial iron powder (200 mesh) in 120 min, and 100% Cr(VI) was removed when the metal to solution ratio was 10 g l⁻¹. The results demonstrates that the Cr(VI) removal percentage was affected apparently by pH, the amount of Fe powder and the reaction temperature. The Cr(VI) removal percentage with nanoscale Fe⁰ was much higher than those with Fe⁰ filings or Fe⁰ powder at the same reaction time. Electrochemical analysis of the reaction process led to the conclusion that the Cr(VI) trended to form Cr(III) hydroxide under the reaction conditions. The kinetics analysis showed that Cr(VI) reduction by Fe⁰ could be described as a pseudo-first-order kinetics model.     

铬渣的热解无害化处理

采用热解工艺无害化处理铬渣,探讨了稻秆在铬渣无害化处理中的作用.研究了热解温度、稻秆与铬渣质量比、铬渣粒径及保温时间对铬渣热解无害化处理的影响,并分析了热解前后热解产物中铬元素形态的变化.结果表明,热解工艺能有效地将铬渣中Cr(Ⅵ)还原,稻秆热解过程中产生的气相挥发分对Cr(Ⅵ)的还原起核心作用.较为适宜的热解条件:热解温度为400 ℃,稻秆与铬渣质量比为0.10,铬渣粒径<2 000 μm,保温时间为10 min.在该热解条件处理下,热解产物中的Cr(Ⅵ)质量浓度为121 mg/kg,低于热解前铬渣中的Cr(Ⅵ)(3 400 mg/kg).热解后,可交换态及碳酸盐结合态铬含量降低,大部分铬转化成了稳定的有机结合态和残渣态,极大地降低了铬渣的危害.第一作者:张大磊,男,1982生,博士研究生,研究方向为固体废弃物热处理.     

Limitations in the determination of maximum residue limits and highest residues of pesticides: Part I

The pesticide usages are controlled by comparing residue concentrations in treated commodities to legally permitted maximum levels (MRLs) determined based on supervised trials designed to reflect likely maximum residues occurring in practice following authorised use. The number of trials available may significantly affect the accuracy of estimated maximum residues. We conducted a study with synthetic lognormal distributions with mean of 1 and standard deviations of 0.8 and 1.0, which reflect the residue distributions observed in practice. The likely residues in samples were modelled by drawing random samples of size 3, 5, 10 and 25 from the synthetic populations. The results indicate that the estimations of highest residues (HR), used for calculation of short-term intake, and the MRLs, serving as legal limits, are very uncertain based on 3–5 trials indicated by the calculated HR_0.975/HR_0.025 and MRL_0.975/MRL_0.025 ratios of 12 and 9, and 13 and 10, respectively, which question the suitability of such trials for the intended purpose. As the 95% range of HR and MRL rapidly decreases with number of trials, ideally ≥15 but minimum 6–8 trials should be used for estimation of HR and MRL according to the current typical practice of Codex Alimentarius.     

绵阳市代表性点位土壤多环芳烃剖面分布特征

通过挑选绵阳市有代表性的点位土壤柱，应用GC MS分析土壤柱垂直剖面中多环芳烃的含量水平，得出其垂直剖面分布特征。结果表明：5~20 cm深度中的PAHs含量最高，40 cm以下则含量锐减。由于表层（0～5 cm）土壤与大气之间的土气交换频繁，PAHs含量相对较低，而5~20 cm处土壤受到表层土壤的遮盖，PAHs富集较高，含量达到整个土壤柱最高值。多环芳烃总体垂直剖面分布特征表现出随深度增加含量减少的趋势。PAHs总含量以江油市点位(33024 ng/g)最高，其次是三台县点位(29989 ng/g)，最低是游仙区点位(11274 ng/g)。研究区主要污染物为Nap、Phe和Chr/y。其中不同的土质、种植物都能影响PAHs的富集和迁移速率，导致含量在不同深度上产生变化。此外，参照有关环境质量标准，发现PAHs总量上江油市点位与三台县点位属于轻微污染、游仙区点位则属于无污染。